Place the magazine on the magazine floorplate and pull out this plate. Use a pointed object (screwdriver, split pin, etc) to press the base plate from below and push the base plate about 5mm out towards the back.ģ. Remove magazine from pistol and make sure no cartridges are in it.Ģ. Grasp the cover by the recess, compress and push onto the grip from the front. The slide must move freely and lie flush with the barrel seat.Ĥ. Pull the slide back a few times and allow it to jump forwards again. Allow the slide to go fully forwards and make sure that the trigger guard is in the normal position again.ģ. Then pull the slide back as far as it will go and press down so that it meshes in the guides. Tension the hammer, introduce the bolt over the barrel from the front and pull the trigger guard downwards. In this way, the locking spring can be very easily inserted in the grip.Ģ. If the locking spring is no longer present in the grip, it can be pre-tensioned on the guide pin and inserted into the transverse hole by means of a small piece of wire (eg a paper clip). If you need to do so, make sure the trigger bar spring is not lost on the right side of the pistol. Note: It is not normally necessary to remove the grip plate.

Caution – hold your hand on the left side of the pistol in such a way that the recoil spring cannot jump out.

The slide can now be pulled backwards and past the guards, lifted up and removed forwards over the barrel (see illustration). Grasp the two recesses between the thumb and index finger and compress so that the cover can be removed forwards.Ĥ. Remove the cover (plastic part below the barrel). Unload pistol, remove magazine and check chamber.ģ.

Hammerli xesse mags